Wolverine PASS-200 Manual do Utilizador

Wolverine DataPASS-200 Portable ScannerUser ManualV1.0

95) Don’t move the scanner and wait for thered LED to go off,and then slide the scanner across on the white area back andforth slowly and smo

106.8 LED light indicationBothGreen andRed LED off ---- Ready to scan. Press SCANbutton to start a scan.Green LED on ---- Scanning in processRed

118. SpecificationsImage sensorA4 Color Contact Image SensorNumber of sensor5138 dots ( 1st-5104 dots available)ResolutionLow resolution: 300x300 dpi

1210. Troubleshooting Tips1. Cannot turn on the scanner.Battery power may be low or batteries were not installed properly.Check the polarities of the

13Damage due to shipping the product to you is covered under this limitedwarranty. Otherwise, this limited warranty does not cover damage dueto ext

14continental United States, where applicable. Shipments to otherlocations will be made freight collect.To obtain service, you must include: (a) a cop

15other peripheral equipment on PASS-200 scanner are excluded fromcoverage.Unauthorized Service or Modification. Defects or damages resultingfrom serv

16Thank you for choosing Wolverine!Having difficulty using PASS-200 Scanner?Please try the following options:Call us at 949-458-9888 M-F 9:00-5:00 P

1Table of Contents1. Before Using the PASS-200 Battery Powered Portable Scanner - 2Having difficulty using this product? -----------------------------

2Thank you for purchasing Wolverine PASS-200 Portable Scanner. Thishandheld battery operated scanner gives you the freedom to scandocuments,

3Do not move or disconnect the device from the computerwhile the device is reading/writing data. This may causedamage to the data and/or the devi

4E-mail or write to our technical support staff [email protected] or to our address:9939 Muirlands Blvd. Irvine, CA 92618.2. FCC NoticeThi

54. Component GuideItemNameFunctions1Battery doorFor 2xAA alkaline batteries2POWER/SCANPower on/off: Press and hold this button for2 - 5 seconds to tu

65. LCD Screen / StatusItemFunctionDescription1SD card indicatorFiles will be stored in MicroSD orSDHC memory cardStorage: Micro-SD or SDHC Card,max.

76. Getting Started6.1 Install battery1)Slide battery door outward.Please see the picture.2) Insert 2 x AA batteries (notsupplied) into the battery

86.4 Set system date and time1) Power on the scanner.2) Use the tip of a paper clip to press “TIME SET” hole.3)Theitem # has 1 to 5 in sequence